4 reasons analysis and solutions for automatic feeding

　　NC CNC feeder has a comprehensive set of functions, wide applicability, simple operation, convenient use, and stable performance. It is a punch feeder favored by stamping manufacturers in the catalog market. However, due to unfamiliar operation or improper maintenance during operation, There are also solid obstacles. Now let's introduce the reasons why the NC feeder can't feed automatically.

　　The customer may appear when using the NC CNC feeder. When switching to the automatic feeder, press the start button to feed the material only once, and then the automatic feeder will no longer be used. At this time, it is switched to manual control. Automatic feeding, if this solid obstacle occurs, the solid obstacle can be eliminated from the following points.

　　1. Check whether the count reaches the set quantity. If the set quantity is reached, the automatic feeding can be started normally after resetting to zero. If the count does not reach the set quantity, please troubleshoot the following problems.

　　2. If it is a single-step feeder, please check whether the feeding length or times setting is set in a step other than the first step. If there is a setting, please reset the length and times setting except for the first step.

　　3. If you use the cutting function as an automatic feeder, you need to check whether the cutting delay and cutting time are adjusted too short, and you need to re-adjust the time.

　　4. If the automatic feeding is still not possible after troubleshooting the above problems, first check whether the cam output of the punch has a solid obstacle, or if the operation and maintenance are improper, and the automatic feeding signal line of the feeder is torn or falls off.

　　The reason why the NC CNC feeder can not automatically feed is basically the above points. If the above points are eliminated, the NC CNC feeder still cannot feed automatically. You can contact Guanniu company and arrange technicians to come to solve it.