Common problems of hook shot blasting machine

　　When we use the hook shot blasting machine, we often encounter various problems. So, what are the common problems of hook shot blasting machine? How to solve it? Let's learn it!

　　Problem 1: The shot blasting machine makes an unusual noise.

　　solution:

　　1. The blades of the pill device are severely worn, resulting in unbalanced operation-please replace the blades in time.

　　2. If the impeller of the shot blaster is severely damaged by friction, please replace the impeller in time.

　　3. What should I do if the bearing burns out? Just need to renew and add grease!

　　Problem 2: Shot blasting machine will always encounter the problem of poor cleaning effect.

　　solution:

　　1. It is possible that the direction of the shot blasting device is wrong, and then the direction of the shot blasting device needs to be adjusted accurately.

　　2. It may be that the shot material of the shot blasting machine has been used for too long or has agglomerated, then we need to replace the shot material.

　　3. The number of projectiles is not enough, please replenish them appropriately.

　　4. The size of the pellets is not suitable for the shot blasting machine, and the appropriate pellets should be re-selected at this time.

　　Problem 3: The bucket elevator does not work often.

　　solution:

　　1. Because of belt slippage, we need to adjust the drive wheel tensioning device of the shot blaster to tighten the belt.

　　2. It may be that the number of shots at the bottom of the lifter of the shot blasting machine is too much. We should shut down and clean up the shots in a certain order.

　　3. It may be jammed by the larger pellets at the bottom of the elevator, then we only need to remove the larger pellets at the bottom of the elevator.

　　The above are the common problems and solutions of the hook shot blasting machine! If you find these problems, please troubleshoot them in time, I hope you can use them safely!