How to adjust the height between the servo feeder and the horizontal line of the stamping die?

　　How to adjust the height between the servo feeder and the horizontal line of the stamping die?Uncoiler factory

　　Servo feeder and punching die horizontal height setting This link is an important part of equipment installation, and is the basic requirement of servo feeder. After purchasing servo feeder, customers need to install it on the punching machine and debug it before it can be put into production and use, so how to correct The installation process of the servo feeder is very important, so how should we handle the adjustment of the height between the servo feeder and the horizontal line of the stamping die?

　　In addition to adjusting the height of the servo feeder and the horizontal line of the stamping die during installation. During production, the operator should adjust and change the height of different stamping die lines, the height of the automatic punch feeder and the die line.

　　Only when the feeding height of the feeder is consistent with the horizontal line of the stamping die can our production process be more accurate and the transmission smoother, so how to adjust it?

　　First of all, we need to determine the position where the new mold horizontal line can adjust the height. The height of the automatic feeding line needs to be increased or decreased by how much distance; after clarifying the feeding height adjustment range of the servo feeder, we need to confirm that the position on the mounting plate of the servo feeder Can the height adjustment bolt be adjusted to the required feeding height after the limit is adjusted;

　　No matter the NC automatic feeder, leveling feeder, yaw feeder, servo feeder and other automatic feeders used in the automatic punch press production line.

　　Most of the installation methods are to install the servo feeder mounting plate on the side of the punch press and then in a fixed position. To ensure stable feeding, this installation method needs to adjust the fixing bolts on the mounting plate according to different molds. , To change the height of the feeding line of the servo feeder, and the adjustment height of the feeding line of the feeder is determined according to the customer's time and the height of the mold.

　　If we can reach our adjustment range, we only need to loosen half of the screws on the mounting plate of the servo feeder until the height adjustment bolt of the servo feeder can be twisted to adjust to the required height and then fix the high-speed roller to the mounting plate. The bolts on it can be tightened