Introduction to a series of working processes of the decoiler production line

　　When the uncoiler production line is working, the lead mechanism is in the feeding state. After the uncoiler is leveled, the sheet material is conveyed, corrected and positioned in the middle of the sizing device. According to the preset size, the material is accurately fed to the shearing machine to achieve When the size is set, the feeding is stopped and the signal is transmitted to the shearing machine. The shearing machine cuts off the plate. The cut plate falls on the hydraulic stacking lifting platform, which is controlled by the electronic control system of the lifting platform. When the number reaches the set number, the production line will automatically stop, controlled by a manual console, and the finished board will be output and sent to the packaging process, and the production line can enter the next working cycle.

　　The feeding, leveling, cross-cutting, blanking, palletizing, etc. of the entire line of the uncoiler are controlled by a microcomputer and coordinated automatically when they work automatically. At the same time, the uncoiler can manually input the size and number of sheets to be processed, set the speed of the flatbed machine, and switch between automatic and manual functions.

News

home

Introduction to a series of working processes of the decoiler production line

Hotline

+86-13692841862

Surface Treatment Equipment

Coil Handling Equipment

Solutions

Application

About us