welcome to MAYFLAY

For consultation/feedback, please call the service hotline: +86-13692841862 Email:info@mayflay.com

Surface treatment Soutions

Coil Handling and Press Feeding Solutions

News

The shot blasting time of the shot blasting machine controls the cost of shot blasting!

  The control between the shot blasting time of the shot blasting machine and the shot blasting cost is that cost saving is a very critical task. Let the editor summarize this knowledge for everyone.

The shot blasting time of the shot blasting machine controls the cost of shot blasting!(图1)

  The longer the shot blasting time, the cleaner and more beautiful the workpiece will be processed. But it also has its drawbacks, that is, if your workpiece is thinner and especially easy to deform, then the longer you shot the blasting time, the greater the problem will be. However, too short shot blasting time will also cause unclean workpieces, which will affect the aesthetics of the product.

  Therefore, the control of the shot blasting time mainly depends on the thickness of the workpiece you need to clean. Because the thickness is different, the thickness of the oxide layer is also different, so the processing time is also different; so there is no specific time requirement, mainly depends on It is determined by the material and thickness of our company's workpieces. The cleaning time of each material is different. Generally speaking, the length of shot blasting time affects the quality of shot blasting. Detailed consultation with the manufacturer should be made according to the material of the cleaned workpiece and the cleaning requirements.

  Time control of shot blasting machine. The longer the shot blasting time, the greater the roughness of the workpiece surface. If the treatment time is too short, the treatment will be dirty and the coating quality will be affected. The processing time is too long, firstly, it will cause energy waste and increased consumption of pellets, and increase the cost; secondly, the roughness of the surface of the workpiece will become larger, resulting in increased coating consumption and decreased anti-corrosion performance. Therefore, reasonable processing time must be controlled. Because the thickness of the steel plate is different, the thickness of its oxide scale is also different, and the shot blasting time used is different. The processing time for workpieces with thin oxide scale is short, and the processing time for workpieces with thick oxide scale and severe rust is correspondingly increased.