Double Hook Type Shot Blasting Cleaning Machine

When adjusting the Double Hook Type Shot Blasting Cleaning Machine of the working principle of the Double Hook Type Shot Blasting Cleaning Machine, pay attention to the position of the directional sleeve of the shot blasting machine so that all the projectiles are projected onto the workpiece to be polished, otherwise it will affect the finishing efficiency. If necessary, find the address of the window, apply black ink or thick paper on a piece of wood, place it on the address of the finished part, ignite the blast machine, and then manually participate in the injection tube of the blast tube. Number of shots, check the address of the projectile.

If the address of the projectile is incorrect, please adjust the direction sleeve to the address you dreamed of. After adjusting the direction sleeve, the load test can be performed. After 30 minutes of shot peening, it will participate in 400 Kg projectiles.

Double Hook Type Shot Blasting Cleaning Machine adopts full-screen ball sand broadband equipment. The wide stripping tower consists of a wide rotating spiral tube, a drum screen and a granule silo. Marugames has a feed port on the funnel to add new particles to the device. The marsh sand mixture flowing from the bucket elevator is conveyed from the screw to the drum screen. The drum screen has an inner spiral member and an outer spiral member.

In the delivery process, the internal spiral sends large particles and debris (such as sand) to the slag discharge port for removal. The mixture of sieve and sand dust sieve is pushed by the outer spiral of the drum, distributed evenly along the entire length of the wide body, and then the particle flow is adjusted to the bottom with a broad-spectrum hammer. A wide range of equipment.

At this time, the blower of the shot blasting machine is ventilated through the ventilation holes of the widening device. Using the principle of gravity wind selection, projectiles and metal oxide scale can be used, projectile rupture and dust, large particle waste flows out of the wide overflow, particles and dust flow out of the waste outlet. Implement reincarnation.

The working condition of the Double Hook Type Shot Blasting Cleaning Machine is very poor. Therefore, maintenance should be carried out quickly and strictly. The machine must strictly follow the operating procedures. The belts in the transmission system, elastic belts for V-belts and chains, and promotional buckets are usually placed. If the board is worn, please use it with obstacles.

After daily work, every consumable of the machine should be cleaned and cleaned. If damaged, it should be replaced quickly. Smoothing should be performed in accordance with the provisions in the manual. It is necessary to check the machine regularly.

Operators and nursing staff must pay attention to these instructions. Those who do not understand the functions and control procedures of the Double Hook Type Shot Blasting Cleaning Machine shall not operate.

　　Automotive Shot Blasting and Peening solutions

　　Sandblasting is to use compressed air to spray abrasive to the surface of workpiece at high speed. The purpose of sandblasting is to improve the appearance quality of workpiece surface by removing oxide layer and rust. Shot peening is to make the high-speed hard particles (generally steel particles) hit the surface of metal workpiece, in order to improve the fatigue strength of metal surface. Sand blasting and shot blasting are two different processes and different tools are used. However, both of them can be recycled.

　　The technology of shot blasting cleaning machine replaces the common cold and hot forming process to form large thin-walled aluminum parts, which can not only avoid the residual tensile stress on the surface of the parts, but also obtain the favorable compressive stress for the parts.

　　It should be noted that the service temperature of the parts treated by shot blasting machine should not be too high, otherwise the compressive stress will disappear automatically at high temperature, thus the expected effect will be lost. Their service temperature is determined by the material of the parts, which is about 260-290 ℃ for general steel parts and 170 ℃ for aluminum parts.