Gas Cylinder Rotary Hooks Shot Blasting Machine

Gas Cylinder Rotary Hooks Shot Blasting Machine switch cleaning process should pay attention to what issues?

1. The operation of Gas Cylinder Rotary Hooks Shot Blasting Machine should be observed carefully. Before and after the change, we should pay attention to some details in daily life. Oil and gas can not ignore the function of the shot blasting machine at work, because it is boring, please pay attention to each shot blasting machine. When shooting, often check and remove the fragments of the sand-proof lenses on the screen, and replace them when you find them on.

2. Clean the equipment frequently to prevent the operator from being scattered in the projectile and being injured. Usually the body is fixed in the examination room. If the loose nut is tightened, it should be checked in time. Always check whether the lifting belt is too loose or touched by passengers, please adjust abnormally and tighten the screw conveyor to check. Generally, when the blade diameter is 20 mm, the blade should be replaced. The transparent lubricant is usually added or replaced according to the lubricated railway system.

3. The small Gas Cylinder Rotary Hooks Shot Blasting Machine is the center of the shooting room cleaner. The character is placed on the turntable. The bearing center at the bottom of the support chamber is driven horizontally by a gear motor fixed on the underside of the legs. The room was very clean. The top is installed on the side of the shaft, the bend is a foot of the elevator and the clean room, the welding support and the left and right side legs, push the internal machine, the elevator hopper, the pill close to the elevator, the slag separator and the slag separation After the steel shot is burned at the entrance, the door enters the bottom of the steel shot. The leaked sand shot blasting container will drive the drive disk and the rotary disk coaxial scraper s, and install the funnel inside the machine into the elevator. One side of the chamber moves forward. By cleaning the room and messing up the filter, and connected to the outlet of the lower part of the dust separation tube of the two slag separators.

4. Always check the indoor cleaning cover for wear. If the wear-resistant manganese rubber plate is worn or damaged, it should be replaced in time. Frequently check the wear of the blasting knife separator and directional bushing. When the blade is worn, the average thickness of the three-point pill window is 1/2, and even the width of the directional sleeve window should be replaced.

5. Gas Cylinder Rotary Hooks Shot Blasting Machine is a special equipment for special process, designed to meet user requirements. Suitable for welding small and medium-sized cast iron, steel castings, forgings and steel plates. The washing machine is mainly used for surface cleaning of parts and other cast iron parts, eliminating sand, rust, dirt and grime, eliminating metal surfaces, eliminating internal pressure of paint, improving fatigue resistance and increasing adhesion. And improve the surface and internal quality. The purpose of the trolley is to shoot, and the mechanism of the shot blasting machine should be objectively cleaned, cleaned and added to the purpose.

　　Automotive Shot Blasting and Peening solutions

　　Sandblasting is to use compressed air to spray abrasive to the surface of workpiece at high speed. The purpose of sandblasting is to improve the appearance quality of workpiece surface by removing oxide layer and rust. Shot peening is to make the high-speed hard particles (generally steel particles) hit the surface of metal workpiece, in order to improve the fatigue strength of metal surface. Sand blasting and shot blasting are two different processes and different tools are used. However, both of them can be recycled.

　　The technology of shot blasting cleaning machine replaces the common cold and hot forming process to form large thin-walled aluminum parts, which can not only avoid the residual tensile stress on the surface of the parts, but also obtain the favorable compressive stress for the parts.

　　It should be noted that the service temperature of the parts treated by shot blasting machine should not be too high, otherwise the compressive stress will disappear automatically at high temperature, thus the expected effect will be lost. Their service temperature is determined by the material of the parts, which is about 260-290 ℃ for general steel parts and 170 ℃ for aluminum parts.