Hook type shot blasting machine

The introduction of the pass-through automatic shelling and cleaning machine to remove rust and scale on the surface is the working principle of the shot blasting technology of the hook type shot blasting machine.

The hook type shot blasting machine uses the high-speed projectile beam to hit the surface of the workpiece to achieve the desired effect. The type of shot blasting machine not only has less environmental pollution, but also has low production costs, which will bring good economic and social benefits definitely.  

In addition, the shot blasting technology of the hook type shot blasting machine can replace the straight steel products of wire drawing enterprises completely.

The design of the hook type shot blasting machine is novel.It is easy to use and maintain.

The hook of the hook type shot blasting machine has the functions of lifting, walking and indoor rotation.

The hook type shot blasting machine has automatic fault detection device and advanced production technology. The hook type shot blasting machine has the characteristics of advanced structure, reasonable design, reliable operation, high production efficiency and so on.

　　Automotive Shot Blasting and Peening solutions

　　Sandblasting is to use compressed air to spray abrasive to the surface of workpiece at high speed. The purpose of sandblasting is to improve the appearance quality of workpiece surface by removing oxide layer and rust. Shot peening is to make the high-speed hard particles (generally steel particles) hit the surface of metal workpiece, in order to improve the fatigue strength of metal surface. Sand blasting and shot blasting are two different processes and different tools are used. However, both of them can be recycled.

　　The technology of shot blasting cleaning machine replaces the common cold and hot forming process to form large thin-walled aluminum parts, which can not only avoid the residual tensile stress on the surface of the parts, but also obtain the favorable compressive stress for the parts.

　　It should be noted that the service temperature of the parts treated by shot blasting machine should not be too high, otherwise the compressive stress will disappear automatically at high temperature, thus the expected effect will be lost. Their service temperature is determined by the material of the parts, which is about 260-290 ℃ for general steel parts and 170 ℃ for aluminum parts.