How to debug the three-in-one automatic feeder equipmen!Coil Straightener Feeder Dealert

　　Under normal circumstances, customers purchase three-in-one automatic feeder equipment. When the entire machine is purchased, the manufacturer may deliver it to the door, including the first installation and commissioning, and after-sales service. But no one can guarantee that the automatic feeder equipment needs to be re-adjusted during the subsequent operation. For example, factors such as changing the thickness of the material need to be adjusted by the customer. Let's look at how to debug the three-in-one automatic feeder equipment!

　　When the feeder is debugged, there is no need to feed, just adjust the screw of the guide plate up and down, and then use the jog mode to smoothly adjust the lower limit of the punch striker. During the operation, pay attention to the guide plate not to press the floating rod too low, otherwise it will cause The floating rod is bent or broken. However, when the punch is to continuously punch, the speed adjustment screw of the feeder must be rotated clockwise, and the slider moves slightly slower, so that you can see whether the nylon gasket and the length fine-tuning screw are encountered when the slider moves back and forth.

　　When debugging the three-in-one automatic feeder equipment for the first time, the sliding block cannot touch the length fine-tuning screw when it can only touch the nylon gasket, you need to adjust the guide screw of the punch down and reversely, but the sliding block is in the length fine-tuning screw The distance between the two sides and the nylon washer is equal. At this time, the speed adjustment screw should be rotated in a counterclockwise direction to make the slider speed normal, and the nylon washer and spacer ring can be touched when the slider moves back and forth.