Importance of Feeding Angle Adjustment of Punch Servo Feeder

　　Stamping processing mode is used by more and more manufacturing industries due to its advantages of low processing cost, high output power, and good quality of products. There are two production methods for stamping processing: single-punch and successive production methods. Single-punch processing uses manual manual feeding and cooperative punching for punching production, while full-automatic processing uses a feeder to realize automatic punching and production for stepping feeding of the punch. Due to the disadvantages of single-punch processing with manual manual feeding, such as high labor intensity, low production power, and high safety hazards, it is gradually replaced by automatic punching production of punch feeders.

　　Only the stamping method of continuous processing in the country was popularized very late. At that time, many stamping customers were using the continuous processing method of deploying servo feeders for the first time, so they were not familiar with the operation and application of the feeder. After replacing the mold with a new product, many feeders have inaccurate feeding. Because of their lack of experience, it is difficult for the operators of these stamping customers to find out where the problem is. They feel that the feeder is not good enough and the quality is poor. .

　　In fact, in most cases, the phenomenon of unstable feeding caused by the punch feeder after die change is not caused by the fault of the feeder itself, but because the operator has not adjusted the angle of the feeder according to the stamping process. Many people who use the servo feeder for the first time After changing the mold for the punch, the customer only adjusted the feeding height of the feeder to make it cooperate with the lower mold height, but did not change the angle of the feeder. The result was that the feeder caused inaccurate feeding. Many customers who use the feeder for the first time do not understand why the angle of the feeder should be adjusted after replacing the mold. In order to solve this doubt, here is a detailed explanation: