Overhead conveyor shot blasting machine with hook

Overhead conveyor shot blasting machine with hook is a device specially used for roughening and cleaning of concrete road surface scum. This equipment can roughen the road surface to a certain degree of explicitness, improve the roughness of the road surface bridge deck, so as to do better Waterproof treatment.

The equipment can be applied to the waterproof and roughening and anti-corrosion construction of tunnel pavement, bridge overpass deck, highway, underground garage, and can also be used in asphalt pavement marking cleaning, large ship deck derusting and other fields, making its surface uniform and rough, The adhesive strength of the waterproof layer and the concrete base is greatly improved, so that the waterproof layer and the bridge deck can be better combined, and at the same time, the cracks of the concrete can be fully exposed, which plays a preventive role.

Airport runway marking cleanup

Due to advanced dust cleaning technology, the working principle and application scope of the pulse stand-alone dust collector The working principle of the pulse stand-alone dust collector is filtered by the air inlet hopper or through the open flange port filter bag room, and the dust-containing gas is filtered through the filter bag It is a clean gas and clean room, and then is discharged by the fan through the clean gas exhaust port. Thirteen. For the inclined surface and structural parts with a horizontal angle greater than 45 degrees, the insulation layer should be provided with a support, and the support should be placed above the flange, etc., and its position does not affect the disassembly of the bolt. When the high-concentration dust flow flows to the separation interface, the dust pollution problems encountered by customers in production

　　Automotive Shot Blasting and Peening solutions

　　Sandblasting is to use compressed air to spray abrasive to the surface of workpiece at high speed. The purpose of sandblasting is to improve the appearance quality of workpiece surface by removing oxide layer and rust. Shot peening is to make the high-speed hard particles (generally steel particles) hit the surface of metal workpiece, in order to improve the fatigue strength of metal surface. Sand blasting and shot blasting are two different processes and different tools are used. However, both of them can be recycled.

　　The technology of shot blasting cleaning machine replaces the common cold and hot forming process to form large thin-walled aluminum parts, which can not only avoid the residual tensile stress on the surface of the parts, but also obtain the favorable compressive stress for the parts.

　　It should be noted that the service temperature of the parts treated by shot blasting machine should not be too high, otherwise the compressive stress will disappear automatically at high temperature, thus the expected effect will be lost. Their service temperature is determined by the material of the parts, which is about 260-290 ℃ for general steel parts and 170 ℃ for aluminum parts.