The principle of the feeder/how does the feeder work?Uncoiler factory

　　The principle of the feeder/how does the feeder work?

　　What is the principle of the feeder? How does the feeder work? How to realize the stable feeding of punch press production! Nowadays, with the development of automation technology, the continuous improvement of manufacturing technology, and the improvement of manufacturing capacity, traditional manufacturing relying on manual development has been eliminated, replaced by fully automated production, and automatic feeding equipment for punch production has emerged. Many customers may still I don't know how the feeder of the punch press works, or what the principle is.

　　So what is the principle of the feeder and how does it work? First of all, we can adjust the appropriate distance between the two sliding seats by turning the adjusting screw according to the material width of the stamping material. Then the stamping material passes through the second linear drive of the feeding device to drive the upper feeding roller to move away from the lower feeding roller, and enters the servo-driven upper and lower feeding rollers. The upper and lower leveling rollers cooperate with each other, and the width is adjusted to achieve material leveling. .

　　The material enters the leveler and is leveled and then enters into the feeder. The width of the material is also adjusted through the adjustable sides, and then driven by the servo-driven roller through the eccentric, it is stable and orderly, and the stamping material is processed according to the cycle time of the punching once. Feed the material to the punch processing area. , That is, after feeding the stamped coil to the upper and lower feeder rollers, use the eccentric wheel to adjust the front and rear distance of the upper and lower feeder rollers. After the adjustment is completed, the servo drive motor runs by driving the connecting rod to rotate, and the connecting rod drives the transmission shaft to rotate back and forth. The transmission shaft drives the lower roller to rotate step by step through a one-way transmission device, and the lower roller and the upper roller rotate synchronously, so that the raw material belt is forwarded step by step.

　　There are many types of feeder equipment, such as stamping manipulators, three-dimensional manipulators, etc. What we are talking about here is a punching feeder for punching and producing coil material, or a punching coil feeder, etc., ordinary manual roller type, but also There are a computer-controlled NC servo feeder and a three-in-one feeder that combines a coil rack, a leveler, a feeding device, and three devices, but no matter what it is called, the main feeding method is the same. The punch can continuously produce auxiliary equipment for stable and efficient stamping