The reason why the production amplitude of the stamping servo feeder is too large!NC feeder factory

　　The reason why the production amplitude of the stamping servo feeder is too large

　　With the advancement of science and technology, the production of numerical control enterprises has realized the automatic production function. Automation can not only reduce labor costs, but also reduce the risk factor. For example, the punch feeder has brought great convenience to the production enterprise. It is very simple and easy to operate in the operation process, and the products produced are of high precision and remarkable results. However, even the best mechanized equipment will encounter some minor problems. Among them, have you encountered the problem of excessive amplitude of the body of the punch feeder? Here is an analysis of the specific reasons for this situation.

　　The CNC punching feeder produces bed jitter during the process of punching the screen, and the operation is quite unstable, sometimes with a slight noise. This situation is mainly caused by the following reasons.

　　1. The reason for the motor of the stamping servo feeder: the motor power is too small, causing the feeder to be unstable or the motor brushes when the feeder is stamping, and the punching feeder will vibrate when it is moving.

　　Second, the reason for the clutch of the punch servo feeder: the clutch is worn for a long time or the fastening screw of the feeder clutch is loose, causing a gap between the clutch and the screw end of the punch feeder and the motor to cause slippage. The punch feeder is in the feeding process Jitter in the process.

　　Third, the reason for the software of the punch servo feeder: the software parameters of the CNC punch feeder are not debugged to reasonable parameters, which may also cause the jitter of the feeding machine body.

　　Fourth, stamping servo feeder lead screw guide reason: the punch feeder should be lubricated strictly in accordance with the instruction manual during normal operation to reduce the wear of the ball screw and increase its life. Once the screw is severely worn, it is also one of the reasons for the jitter in the operation of the feeder. . If your punch feeder also has the problem of body shake, remember to check it in accordance with the above four aspects. If all are in good condition, remember to ask the feeder manufacturer to visit and repair it in time.